Tel: 01243 261119
Mob: 07939 072008
Driving test candidates will be asked two questions, one “show me" and one "tell me". One or both questions answered incorrectly will result in one driving fault being recorded.
Open the bonnet, identify where you would check the engine oil level and tell me how you would check that the engine has sufficient oil.
Identify dipstick and describe checking of oil level against the minimum / maximum markers.
Show me / explain how you would check that the power assisted steering is working before starting a journey.
If the steering becomes heavy the system may not be working properly. Before starting a journey two simple checks can be made. Gentle pressure on the steering wheel, maintained while the engine is started, should result in a slight but noticeable movement as the system begins to operate. Alternatively turning the steering wheel just after moving off will give an immediate indication that the power assistance is functioning.
Open the bonnet, identify where you would check the engine coolant level and tell me how you would check the engine has the correct level.
Identify max / min level markings on header tank.
Show me how you would check the parking brake for excessive wear.
Apply footbrake firmly. Demonstrate by applying parking brake that when it is fully applied it secures itself, and is not at the end of the working travel.
Identify where the windscreen washer reservoir is and tell me how you would check the windscreen washer level
Identify reservoir and explain that you need to top it up regularly.
Show me how you would check if the horn is working (off road only).
Press the horn button.
Open the bonnet, identify where the brake fluid reservoir is and tell me how you would check that you have a safe level of hydraulic brake fluid
Identify reservoir, check level against min / max marks.
Show me how you would check that the direction indicators are working.
Applying the indicators or hazard warning switch and checking functioning of all indicators by walking around the car.
Tell me how you would check that the brake lights are working on this car
Operate brake pedal, make use of reflection in windows, garage doors etc. or ask someone to help.
Tell me how you would check that the brakes are working before starting a journey.
Brakes should not feel spongy or slack. Brakes should be tested as you set off. Vehicle should not pull to one side.
Tell me how you would check that the headlights & tail lights are working.
Explain that you would turn on the ignition, turn on headlight switch, walk round vehicle checking all are operating correctly.
Tell me how you would cheek the tyres to ensure that they have sufficient tread depth and that their general condition is safe to use on the road.
No cuts and bulges. 1.6mm of tread depth across the central 3⁄4 of the breath of the tyre and around the entire outer circumferences.
Tell me where you would find the information for the recommended tyre pressure for this car and how tyre pressures should be checked.
Manufacturer’s guide, use a reliable pressure gauge, check and adjust pressures when tyres are cold, don't forget the spare tyre, remember to refit valve caps.
Show me how you would clean the windscreen using the windscreen washer and wipers.
Wash the windscreen (turn ignition on first).
Show me how you would set the demister controls to clear all the windows effectively, this should include both front and rear screens.
Set all relevant controls including; fan, temperature, air direction / source and heated screen to clear windscreen and windows. Engine does not have to be started for this demonstration.
Show me how you would switch on the rear fog
light and explain when you would use it. (No need to exit vehicle).
Turn on the ignition, turn on headlights, pull headlight switch towards you. Check warning light on dashboard is on. Explain you would use them if visibility is 100m or less.
Show me how you switch your headlight from
dipped to main beam and explain how you would
know the main beam is on whilst inside the car.
Turn on the ignition, turn on headlights, pull indicator lever towards you, check warning light on dashboard is on.
Tell me Tell me how you make sure your head restraint is correctly adjusted so it provides the best protection in the event of a crash.
The head restraint should be adjusted so the rigid part of the head restraint is at least as high as the eye or top of the ears, and as close to the back of the head as is comfortable. N.B. Some restraints might not be adjustable.
Tell me how you would know if there was a
problem with your anti lock braking system.
Warning light on the dashboard should illuminate if there is a fault with the anti lock braking system.
Download question and answers
Download Questions and Answers
Maintenance Questions to be used on the Driving Test.